Quick Installation Guide

~3~
~4~
Pole Mount
1. Connect the Ethernet cable (RJ45) to the correct ports of your
GWN7630LR and insert the cover bracket.
2. Connect each antenna to an antenna connector by rotating it
clockwise.
3. Attach the Base Bracket with screws (PM 3.0 x 7) on the back of
GWN7630LR access point.
1
2
3
4
5
1
2
3
Wall Mount
5
6
4. Insert screws (PA 3.5x33) through the Base Bracket and mark the
mounting screw holes on the wall using a pencil.
5. Drill the holes in the spots that you have marked and slide the anchors
into the wall. Secure the GWN7630LR access point to the wall by
inserting the screws into the anchors.
Wall
1. Connect the Ethernet cable (RJ45) to the correct ports of your
GWN7630LR and insert the cover bracket.
2. Connect each antenna to an antenna connector by rotating it
clockwise.
3. Attach the Base Bracket with screws (PM 3.0 x 7) on the back of
GWN7630LR access point.
4. Open the metal straps by turning the locking mechanism counter-
clockwise. You can loosen it by hand or use a athead screwdriver.
5. Straighten out the end of the metal straps and slide it through the back
of the base bracket.
6. Wrap the metal strap around the pole and use a athead screwdriver
to tighten the locking mechanism by turning it clockwise.
Pole