User's Manual

Firmware Version 1.0.0.32 UCM6102/6104/6108/6116 USER MANUAL Page 22 of 110
 Status: Displays PBX status, System Status and CDR.
 PBX: To configure extensions, call routes, call features, internal options, IAX settings and SIP
settings.
 Settings: To configure network settings, change password, LDAP Server, HTTP Server, Email
Settings and Time Settings.
 Maintenance: To perform firmware upgrade, backup configurations, cleaner setup, reset/reboot,
syslog setup and troubleshooting.
SAVING AND APPLYING CHANGES
After configuring the web GUI options in one page, click on the "Save" button on the bottom of the page (if
displayed). After saving all the changes, make sure click on "Apply Changes" button on the top right corner
to submit all the changes. Follow the prompted message to reboot the device if it's required.
MAKING YOUR FIRST CALL
Power up the UCM6102/UCM6104/UCM6108/UCM6116 and your phone with network connected. Then
follow the steps below to make your first call.
1. Log in the UCM6102/UCM6104/UCM6108/UCM6116 web GUI, go to PBX->Basic/Call
Routes->Extensions;
2. Click on "Create New User" to create a new extension. You might need User ID, Password and
Voicemail Password information to register and use the extension later;
3. Register the extension on your phone with the User ID, Password information;
4. When your phone is registered with the extension and ready, dial *97 to access the voicemail box. Enter
the Voicemail Password and you will be prompted with the Voice Mail Main menu.
5. You are successfully connected to the PBX system now.