User's Manual

Firmware Version 1.0.0.32 UCM6102/6104/6108/6116 USER MANUAL Page 23 of 110
SYSTEM SETTINGS
This section explains configurations for system-wide parameters on the
UCM6102/UCM6104/UCM6108/UCM6116. Those parameters include Network Settings, Change
Password, LDAP server, HTTP server, Email settings and Time Settings.
NETWORK SETTINGS
LAN/WAN/802.1X SETTINGS
After successfully connecting the UCM6102/UCM6104/UCM6108/UCM6116 to the network for the first time,
users could login the Web GUI and go to Settings->Network Settings to configure the network parameters
for the device depending on the network environment. The settings are similar for
UCM6104/UCM6108/UCM6116. The UCM6102 supports both WAN port and LAN port, with Router or
Switch mode function configurable on the LAN port. Select each tab in the Network Settings page to
configure LAN settings, WAN settings (UCM6102 only) and 802.1X.
Please refer to the following tables for the network configuration parameters on
UCM6104/UCM6108/UCM6116 and UCM6102 respectively.
Table 7: NETWORK SETTINGS
Settings -> Network Settings -> LAN
IP Method
Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
IP Address
Enter the IP address for static IP settings.
Gateway IP
Enter the gateway IP address for static IP settings.
Subnet Mask
Enter the subnet mask address for static IP settings.
DNS Server 1
Enter the DNS server 1 address for static IP settings.
DNS Server 2
Enter the DNS server 2 address for static IP settings.
User Name
Enter the user name to connect via PPPoE.
Password
Enter the password to connect via PPPoE.
Preferred DNS Server
Enter the preferred DNS server address.
Settings -> Network Settings -> 802.1X
802.1X Mode
Select 802.1X mode. The default setting is "Disable". The supported 802.1X
mode are:
 EAP-MD5