User's Manual

Firmware Version 1.0.0.32 UCM6102/6104/6108/6116 USER MANUAL Page 35 of 110
Table 13: Auto Provision Setting
Enable Zero Config
Enable or disable the zero config feature on the PBX. The default setting
is Yes.
Automatically Assign Extension
If enabled, when the device is discovered, the PBX will automatically
assign an extension to the device. The default setting is disabled.
Starting Extension
Specify the starting extension to be created/assigned. If the extension is
assigned to existing device already, this extension will be skipped and
the next available extension will be used. The default setting is 6000.
Generate Random Password
If enabled, random password will be generated for the extension when
it's created. Otherwise, default password will be used.
Default Password
Specify default password for the extension if no random password is
generated. The default setting is "admin".
Click on "Save" to start the discovery and provisioning process. Reboot the device and the assigned
extension will be registered after booting up.
MANUAL PROVISIONING
DISCOVERY
Users could manually discover the device by specifying the IP address or scanning the entire network.
Three methods are supported to scan the devices.
 PING
 ARP
 SIP MESSAGE (OPTIONS)
Click on "Auto Discover", fill in the scan method and scan IP. Then click on "Save" to start discovering the
devices within the same network.