User's Manual

ManualsBrandsGrandstream Networks ManualsElectronicsIP PBX

Firmware Version 1.0.0.32 UCM6102/6104/6108/6116 USER MANUAL Page 46 of 110

hangup polarity switch. (default: 600ms)",

RX Gain

Gain for the receive channel of analog FXO port. Range: -13.5 (dB) to +

12.0 (dB).

TX Gain

Gain for the transmit channel of analog FXO port. Range: -13.5 (dB) to +

12.0 (dB).

Ring Timeout

unit: milisecond . Trunk (FXO) devices must have a timeout to determine

if there was a hangup before the line was answered. This value can be

tweaked to shorten how long it takes before asterisk considers a

non-ringing line to have hungup.",

Use CallerID

Enabling this option enabled Caller ID detection

Caller ID Start

This options allows one to define the start of a Caller ID signal: Ring, to

start when a ring is received, or Polarity, to start when a polarity reversal

is started

Current Disconnect Threshold

(ms)

This is the periodic time in milliseconds that the PBX will use to check on

a voltage drop in the line. Default setting is 200ms.

CID Signalling

This option defines the type of Caller ID signalling to use: bell (bell202

as used in the United States), v23 (as used in the UK), v23_jp (as used

in Japan), or dtmf (as used in Denmark, Sweden, and Holland)."

Tone Country

Select country for tone settings. You can also select Custom and set the

values manually.

Busy Tone

Syntax:

f1=val[@level][,f2=val[@level]],c=on1/off1[-on2/off2[-on3/off3]];

Frequencies are in Hz and cadence on and off are in ms.

Frequencies Range: [0, 4000)

Busy Level Range: (-300, 0)

Cadence Range: [0, 16383].

Select Tone Country "Custom" to edit manually.

Default value:

f1=480,f2=620,c=250/250

Congestion Tone