User's Manual

Firmware Version 1.0.0.32 UCM6102/6104/6108/6116 USER MANUAL Page 47 of 110
Default value:
f1=480,f2=620,c=250/250
VOIP TRUNKS
Go to Web GUI->PBX->Basic/Call Routes->VoIP Trunks to add and edit VoIP trunks.
 Click on "Create New SIP/IAX Trunk" to add a new VoIP trunk first. Then click on to configure more
options for the VoIP trunk.
 Click on to delete the VoIP trunk.
The VoIP trunk options are listed in the table below.
Table 17: VoIP Trunk Configuration Parameters
Create New SIP/IAX Trunk
Type
Select the VoIP trunk type.
 Peer SIP trunk
 Register SIP trunk
 Peer IAX trunk
 Register IAX trunk
Provider Name
A unique label to help you identify this trunk when listed in outbound
rules, incoming rules etc.",
Host Name
IP address or URL for your VoIP providers server.",
VoIP Trunk Configuration Parameters
Provider Name
Configure the provider name for the VoIP trunk.
Host Name
Configure the host name for the VoIP trunk.
Transport
Configure the SIP transport protocol "UDP", "TCP" or "TLS".
Caller ID
Configure the Caller ID.
CallerID Name
The new name of caller to replace when extension was not set CallerID
Name.",
Codec Preference
Select audio and video codec for the VoIP trunk. The available codecs
are:
PCMU, PCMA, GSM, G.726, G.722, G.729, G.723, ILBC, ADPCM,
LPC10, H.264, H.263, H.263p.
Enable Qualify
If enabled, the PBX will send SIP OPTIONS to check if the device is still
alive. The default setting is disabled.
Enable FAX Detect
Enable both CNG and T.38 detect. The default setting is disabled.