User's Manual

Firmware Version 1.0.0.32 UCM6102/6104/6108/6116 USER MANUAL Page 49 of 110
CALL ROUTES
OUTBOUND ROUTES
An outgoing calling rule pairs an extension pattern with a trunk used to dial the pattern. This allows different
patterns to be dialed through different trunks (e.g., "Local" 7-digit dials through a FXO while "Long distance"
10-digit dials through a low-cost SIP trunk). Users can also set up a failover trunk to be used when the
primary trunk fails.
Go to Web GUI->PBX->Basic/Call Routes->Outbound Routes to add and edit outbound rules.
 Click on "Create New Outbound Rule" to add a new outbound route.
 Click on to edit the outbound route.
 Click on to delete the outbound route.
 Click on to move the outbound route up/down to arrange the sequence.
Table 18: Outbound Route Configuration Parameters
Calling Rule Name
Configure the calling rule name (e.g., local).
Pattern
 All patterns are prefixed with the "_".
 X: Any Digit from 0-9.
 Z: Any Digit from 1-9.
 N: Any Digit from 2-9.
 ".": Wildcard. Match one or more characters.
 "!": Wildcard. Match zero or more characters immediately.
Example:
[12345-9]: Any digit from 1 to 9.
Privilege Level
Select privilege level for the outbound rule.
 Local: The lowest level required. All users can use this rule.
 National: Users with National level or International level are allowed
to use this rule.
 International: The highest level required. Only users with
international level can use this rule.
Pin Set
Configure the password for users to use this rule.
Send This Call Trough Trunk