User's Manual

Firmware Version 1.0.0.32 UCM6102/6104/6108/6116 USER MANUAL Page 53 of 110
CONFERENCE BRIDGE
Conference bridge configurations can be accessed under Web GUI->PBX->Call Features->Conference.
Users could create, edit, view and delete conference bridges. The conference room status and activity will
show in the page as well.
 Click on "Create New Conference Room" to add a new conference bridge.
 Click on to edit the conference room.
 Click on to invite a user to the conference. The user will receive the ring to join the conference.
 Click on to kick a participant in the conference. This will hang up the conference call on the user.
 Click on to lock the conference room.
 Click on to delete the conference bridge.
Table 20: Conference Bridge Configuration Parameters
Extension
Configure the conference number for the users to dial and join the
conference.
Password
When configured, the users who would like to join the conference call
must enter this password before accessing the conference room.
Admin Password
Configure the password to join the conference room as administrator.
Enable Caller Menu
When enabled, conference participant could press the * key to access
the conference bridge menu. The default setting is disabled.
Record conference
When enabled, the calls in this conference room will be recorded in
a .wav format file. The default setting is disabled.
Quite Mode
When enabled, if there are users entering or leaving the conference
room, voice prompt or notification tone won't be played. The default
setting is disabled.
Wait For Admin
When enabled, the participants will not hear each other until the admin
joins the conference room. The default setting is disabled.
Enable User Invite
When enabled, users could press 0 to invite other users to join the
conference. The default setting is disabled.
Note: