User's Manual

Firmware Version 1.0.0.32 UCM6102/6104/6108/6116 USER MANUAL Page 69 of 110
FAX/T.38
On the UCM6102/6104/6108/6116, the Fax extension can receive T.38 Fax to the specified Email address.
Fax/T.38 settings can be accessed via Web GUI->PBX->Internal Options->FAX/T.38.
CONFIGURING FAX/T.38
 Click on "Create New Fax Extension". In the popped up window, fill the extension, name and Email
address to send the received FAX to.
 Click on "Settings to Fax" to configure the following options.
Table 27: FAX/T.38 Settings
Enable Error Correction Mode
(ECM)
Enable ECM for the Fax.
Maximum Transfer Rate
Configure the maximum transfer rate during the Fax rate negotiation.
The possible values are 2400, 4800, 7200, 9600, 12000 and 14400. The
default setting is 14400.
Minimum Transfer Rate
Configure the minimum transfer rate during the Fax rate negotiation. The
possible values are 2400, 4800, 7200, 9600, 12000 and 14000. The
default setting is 2400.
Default Email Address
Configure the Email address to send the received Fax to if user's Email
address cannot be found.
 Click on to edit the Fax extension.
 Click on to delete the Fax extension.
Note:
Users could also use Fax2Mail if "FaxDetect" option is enabled for the user and VoIP trunk. The Fax signal
will be detected during talking, and the detected Fax will be received and sent to user's Email. If user's
Email address is not configured, Fax will be sent to the default Email address in Table 27: FAX/T.38 Settings.
If the default Email address is empty, Fax will not be received.