User's Manual

Firmware Version 1.0.0.32 UCM6102/6104/6108/6116 USER MANUAL Page 73 of 110
voicemail box.
Voice Mail Main
 Default Code: *97.
 Press *97 to access the voicemail box.
Agent Pause
 Default Code: *83.
 Pause the agent in all call queues.
Agent Unpause
 Default Code: *84.
 Unpause the agent in all call queues.
Paging Prefix
 Default Code: *81.
 To page an extension, enter the code followed by the
extension number.
Intercom Prefix
 Default Code: *80.
 To intercom an extension, enter the code followed by the
extension number.
Call Pickup
 Default Code: **.
 To pick up a call for extension xxxx, enter the code followed by
the extension number xxxx.
INTERNAL OPTIONS/RTP SETTINGS
RTP Start
RTP port starting address. The default setting is 10000.
RTP End
RTP port ending address. The default setting is 20000.
Strict RTP
Enables/disables strict RTP protection. When enabled, RTP packets
that do not come from the source of the RTP stream will be dropped.
The default setting is "Disable".
RTP Checksums
Enables/Disables RTP Checksums. The default setting is "Disable".
INTERNAL OPTIONS/HARDWARE CONFIG
Analog Hardware
Options
Select Loop Start or Kewl Start for each FXS port and FXO port.
Tone Region
Select country for default tones (dial tone, busy tone, ring tone and etc.
Advanced Settings
FXO Opermode
Specify On Hook Speed, Ringer Impedance, Ringer Threshold, Current
Limiting, TIP/RING voltage adjustment, Minimum Operational Loop