User's Manual

Firmware Version 1.0.0.32 UCM6102/6104/6108/6116 USER MANUAL Page 74 of 110
Current, and AC Impedance as predefined for your country's analog line
characteristics. Select the country in the list. FCC is equivalent to United
States. TBR21 is equivalent to Austria, Belgium, Denmark, Finland,
France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg,
Netherlands, Norway, Portugal, Spain, Sweden, Switzerland, and the
United Kingdom. If option is specified, FCC will be used by default.
ACIM Override
Check to override AC Impedance.
FXS Opermode
Specify On Hook Speed, Ringer Impedance, Ringer Threshold, Current
Limiting, TIP/RING voltage adjustment, Minimum Operational Loop
Current, and AC Impedance as predefined for your country's analog line
characteristics. Select the country in the list. FCC is equivalent to United
States. TBR21 is equivalent to Austria, Belgium, Denmark, Finland,
France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg,
Netherlands, Norway, Portugal, Spain, Sweden, Switzerland, and the
United Kingdom. The default setting is FCC.
TISS Override
Check to override Two-Wire Impedance Synthesis.
PCMA Override
Specifies the codec to be used for analog lines. North American users
should choose PCMU. All other countries, unless otherwise known,
should be assumed to be PCMA. If no user choice is specified, the
default is PCMU.
Boost Ringer
Configure whether normal ringing voltage (40V) or maximum ringing
voltage (89V) for analog phones attached to the FXS port is required.
The default setting is Normal.
Fast Ringer
Configure to increase the ringing speed to 25HZ. This option can be
used with "Low Power" option. The default setting is "Normal".
Low Power
Configure the peak voltage during "Fast Ringer" operation. This option is
used with "Fast Ringer" option. The default setting is "Normal".
Ring Detect
Configure ring detection. If set to "Full Wave", false ring detection will be
prevented for lines where Caller ID is sent before the first ring and
proceeded by a polarity reversal, as in UK. The default setting is
"Standard".
MWI Mode
Configure the type of Message Waiting Indicator detection on trunk
(FXO) interfaces.
 None: No detection
 FSK: Frequency Shift Key detection
 NEON: Neon MWI detection.
The default setting is "None".