User's Manual

Firmware Version 1.0.0.32 UCM6102/6104/6108/6116 USER MANUAL Page 83 of 110
Note:
Some devices do not support this (especially if one of them is behind
NAT).
SIP SETTINGS/ToS
The following options are provided to configure SIP ToS on the UCM6102/UCM6104/UCM6108/UCM6116.
ToS For Signaling Packets
Configure the Type of Service for SIP packets. The default setting is
None.
ToS For RTP Audio Packets
Configure the Type of Service for RTP audio packets. The default
setting is None.
ToS For RTP Video Packets
Configure the Type of Service for RTP video packets. The default setting
is None.
Default Incoming/Outgoing
Registration Time
Configure the default length of time (in seconds) of incoming/outgoing
registration. The default setting is 120.
Max Registration/Subscription
Time
Configure the maximum length of time (in seconds) of incoming
registration and subscription allowed by the PBX. The default setting is
3600.
Min Registration/Subscription
Time
Configure the minimum length of time (in seconds) of incoming
registration and subscription allowed by the PBX. The default setting is
60.
Music On Hold Interpret
Configure the Music On Hold class for the channel when being put on
hold. This is used when the Music On Hold class is not set on the
channel in the dialplan and the peer channel placing the call on hold
doesn't suggest the Music On Hold class neither. The default Music On
Hold class will be used if not specified.
Music On Hold Suggest
Configure the Music On Hold class to suggest to the peer channel when
placing the peer on hold. It can be specified globally or per user/per
peer. The default Music On Hold class will be used if not specified.
Enable Relaxed DTMF
Configure to relax the DTMF handling. The default setting is disabled.
DTMF Mode
Select DTMF mode to send DTMF. The default setting is RFC2833. If
"Info" is selected, SIP INFO message will be used. If "Inband" is
selected, 64-kbit codec PCMU and PCMA are required. When "Auto" is
selected, RFC2833 will be used if offered, otherwise Inband will be
used.
RTP Timeout
If there is no RTP activity in the timeout (in seconds) configured in this
option, the call will be terminated. The default setting is no timeout. This