User manual

FIRMWARE VERSION 1.0.5.15 GXP1100/GXP1105 USER MANUAL Page 35 of 47
Use NAT IP
The NAT IP address used in SIP/SDP messages. This field is blank at
the default settings. It should ONLY be used if it's required by your ITSP.
STUN Server
The IP address or Domain name of the STUN server. STUN resolution
results are displayed in the STATUS page of the Web GUI. Only
non-symmetric NAT routers work with STUN.
Settings -> Call Features
Off-hook Auto Dial
Conf
igures a User ID/extension to dial automatically when the phone is
off
hook. The phone will use the first account to dial out. The default
setting is "No".
Off-hook Timeout
If configured, when the phone is on hook, it will go off
hook after the
timeout (in seconds). The default value is 30 seconds.
Disable Call Waiting Disables the call waiting feature. The default setting is "No".
Disable Call Waiting Tone
Disables the call waiting tone when call waiting is on. The default setting
is "No".
Disable Direct IP Call Disables Direct IP Call. The default setting is "No".
Use Quick IP Call mode
When set to "Yes", users can dial an IP address under the same
LAN/VPN segment by entering the last octet in the IP address. To dial
quick IP call, off hook the phone and dial #XXX (X is 0-
9 and XXX
<=255), phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is "No".
Disable Conference Disables the Conference function. The default setting is "No".
Enable MPK sending DTMF
Enables Multi Purpose Key to send DTMF during the call. The default
setting is "No".
Disable Transfer Disables the Transfer function. The default setting is "No".
In-call dial number on pressing
transfer key
Configures the number for the phone
to dial as DTMF during the call
using TRAN button.
Auto-Attended Transfer
If set to "Yes", the phone will use attended transfer by default. The default
setting is "No".
Do Not Escape # as %23 in
SIP URI
Specifies whether to replace # by %23 or not for some special situations.
The default setting is "No".
Click-To-Dial Feature Enables Click-To-Dial feature. The default setting is "Disabled".
Call History Flash Writing:
Write Timeout
Defines the interval (in seconds) to save the call history to phone's flash.
The default value is 300 seconds.
Call History Flash Writing: Defines the number of unsaved logs before written to phone's flash. The