User's Manual

Grandstream Networks, Inc. GXV3140 USER MANUAL Page 33 of 83
FIRMWARE VERSION 1.0.1.18 Updated : 09/2009
to a telephone number or an actual telephone number.
Authenticate ID The authenticate ID for the SIP user. It can differ or be the same as the SIP user
ID.
Authenticate password The password that the GXV uses to authenticate with the ITSP (SIP) server.
After it is saved, this will appear as blank for security reasons. The maximum
length is 25 characters.
Voice Mail UserID When this is configured, the user can dial to the voicemail server using the
MESSAGE button. This ID is normally the feature code for Voice Mail.
Name The Caller ID that will be displayed for the account.
User ID is phone
number:
If the Video phone has an assigned PSTN number, this field should be set to
“YES”. Otherwise, set it to “NO”. If “YES” is set, a “user=phone” parameter will
be attached to the “From header” in the SIP request to indicate the E.164
number.
Account/Network Settings
Outbound Proxy IP address or Domain name of the Outbound Proxy, or Media Gateway, or
Session Border Controller. Used by the GXV3140 for firewall or NAT penetration
in different network environments. If a symmetric NAT is detected, STUN will not
work and ONLY an Outbound Proxy will work.
DNS Mode The default is set to A Record. If the user wishes to locate the server by DNS
SRV, the user may select SRV or NATPTR/SRV.
NAT Traversal This setting decides whether the NAT traversal mechanism is activated. If it is set
to “Yes” and STUN server is configured, the GXV3140 will route according the
STUN server.
In this mode, the STUN client embedded in the phone will communicate with the
appointed STUN server to examine which type of Firewall/NAT setting is
employed. If the type of NAT detected is Full Cone, Restricted Cone or
Port-Restricted cone, the phone will try to use public IP addresses and port in all
the SIP and SDP messages.
If the “NAT Traversal(STUN)” is configured to be “No, but keep-alive”, the phone
will send an empty SDP packet (without payload data) to the SIP server once in
20 seconds to keep the NAT port open. If an outbound proxy server is used,
please configure this to be “NO”.
Proxy Require Notifies the SIP server that the unit is behind a NAT/Firewall.