User's Manual

Grandstream Networks, Inc. GXV3174 USER MANUAL Page 52 of 59
FIRMWARE VERSION 1.0.1.1 Updated : 3/2012
Example of a simple dial plan used in a Home/Office in the US:
{ ^1900x. | <=1617>[2-9]xxxxxx | 1[2-9]xx[2-9]xxxxxx | 011[2-9]x. | [3469]11 }
Explanation of example rule (reading from left to right):
• ^1900x. - prevents dialing any number started with 1900
• <=1617>[2-9]xxxxxx - allows dialing to local area code (617) numbers by
dialing
7 numbers and 1617 area code will be added automatically
• 1[2-9]xx[2-9]xxxxxx |- allows dialing to any US/Canada Number with 11
digits
length
• 011[2-9]x. - allows international calls starting with 011
• [3469]11 - allow dialing special and emergency numbers 311, 411, 611 and
911
NOTE: In some cases where the user wishes to dial strings such as *123 to
activate voice mail or other applications provided by their service provider,
the * should be predefined inside the dial plan feature. An example dial plan
will be: { *x+ } which allows the user to dial * followed by any length of
numbers.
Early Dial The default setting is NO. Use only if the proxy supports 484 response.
Refer to Use Target
Contact
The default is NO. If set to YES, then for Attended Transfer, the “Refer-To”
header uses the transferred target’s contact header information.
Auto Answer The default setting is NO. If it is set to YES, the GXV3175 will play a “beep”
sound and answer the phone automatically on the speaker.
Send Anonymous If set to YES, the “From” header in the outgoing SIP messages will be set to
anonymous to block the caller ID from displaying. The default setting is NO.
Anonymous Call Rejection
The default setting is NO；If set to YES，any anonymous call will be rejected
（with 486 Busy message）
Call Log Options to log calls are Log All, Log Incoming/Outgoing Only(missed calls
will not be recorded), Disable All
Special Feature Different soft switch vendors have special requirements; therefore users
may need to select special features to meet these requirements. Users can
choose from Standard, CBCOM, RNK, China Mobile, ZTE IMS and Mobotix
depending on their need.
The default setting is Standard.
Feature Key Sync Default is “No”. This option is to synchronize DND/Call Forward features
with Broadsoft. When set to “Yes”, a SUBSCRIBE will be sent out
periodically to the server. Then when DND/Call Forward features Call
Forward No Answer, Unconditional Call Forward and Call Forward on Busy)
are configured or changed on the phone and the Broadsoft server side,