User's Manual

Firmware Version 1.0.1.54
GXV3240D Administration Guide
Page 48 of 83
Send Anonymous
If set to "Yes", the "From" header in outgoing INVITE messages will be
set to anonymous, essentially blocking the Caller ID to be displayed.
The default setting is "No".
Anonymous Call Rejection
If set to "Yes", anonymous calls will be rejected. The default setting is
"No".
Call Log
Configures Call Log setting on the phone. You can log all calls, log
incoming/outgoing calls (missed calls will not be logged), or disable
call log. The default setting is "Log All".
Special Feature
Different soft switch vendors have special requirements. Therefore
users may need select special features to meet these requirements.
Users can choose from Standard, Broadsoft, CBCOM, RNK, China
Mobile, ZTE IMS, Mobotix, ZTE NGN, or Huawei IMS depending on
the server type. The default setting is "Standard".
Feature Key Synchronization
This feature is used for Broadsoft call feature synchronization. When
it's enabled, DND, Call Forward features and Call Center Agent status
can be synchronized between Broadsoft server and phone. The
default setting is "Disabled".
Enable Call Features
If set to "Yes", the call features using star codes on the phone will be
supported locally. Otherwise, the feature code will need to be provided
from the server side. The default setting is "No".
No Key Entry Timeout(s)
Defines the timeout (in seconds) for no key entry. If no key is pressed
after the timeout, the digits will be sent out. The default value is 4
seconds. The valid range is from 1 to 15.
Ring Timeout(s)
Defines the timeout (in seconds) for the rings on no answer. The
default setting is 60. The valid range is from 10 to 300.
Transfer on 3-way Conference
Hang up
If set to "Yes", when the phone hangs up as the conference initiator,
the conference call will be transferred to the other parties so that other
parties will remain in the conference call.
Use # as Dial Key
Allows users to configure the "#" key as the "Send" key. If set to "Yes",
the "#" key will immediately dial out the input digits. In this case, this
key is essentially equivalent to the "Send" key. If set to "No", the "#"
key is included as part of the dialing string and please make sure the
dial plan is properly configured to allow dialing # out.
Conference URI
Configures Conference URI for N-way conference (Broadsoft
Standard).
Broadsoft Call Center
The default setting is "No". When set to "Yes", a soft key "CallCenter"
is displayed on LCD dial screen for the Broadsoft account. User can
access different Broadsoft Call Center agent features via this softkey.