User's Manual

P a g e | 62
GXW42xx User Manual
Version 1.0.5.43
Ring Tones
Distinctive Ringtone
Customizes the Ring Tone 1 to 3 with associate caller ID: when
selected, if caller ID is configured, then the device will ONLY use this
ring tone when the incoming call is from the Caller ID. System Ring
Tone is used for all other calls. When selected but no Caller ID is
configured, the selected ring tone will be used for all incoming calls
using the FXS port. Distinctive ring tones can be configured not only
for matching a whole number, but also for matching prefixes. In this
case the symbol “x+” will be used.
For example: if configured as 617x+, Ring Tone 1 will be used in case
of call arrived from the area code 617. Any other incoming call will ring
using cadence defined in parameter System Ring Cadence located
under Advanced Settings Configuration page.
Note: If server supports Alert-Info header and standard ring tone set
(Bellcore) or distinctive ring tone 1-10 is specified, then the ring tone
in the Alert-Info header from server will be used. Bellcore rings and
tones are independent from custom ring tones.
The custom ring tones can also be specified by alert-info header, for
example Alert-Info: ;info=ring5
Ring Tones
Configure ring cadences according to preference.
TABLE 11: FXS PORTS
Port Settings
SIP User ID
User account information, provided by VoIP service provider (ITSP).
Usually in the form of digit similar to phone number or actually a phone
number.
Authenticate ID
SIP service subscriber’s Authenticate ID used for authentication. Can
be identical to or different from SIP User ID.
Password
SIP service subscriber’s account password for GXW42XX to register to
(SIP) servers of ITSP.