User's Manual

Table Of Contents

P a g e | 22

HT812/HT814 User Guide

Configuring The HT812/HT814 Through Voice Prompts

As mentioned previously, The HT812/HT814 has a built-in voice prompt menu for simple device

configuration. Please refer to “Understanding HT812/HT814 Interactive Voice Prompt Response Menu” for

more information about IVR and how to access its menu.

 DHCP MODE

Select voice menu option 01 to allow the HT812/HT814 to use DHCP.

 STATIC IP MODE

Select voice menu option 01 to allow the HT812/HT814 to enable the STATIC IP mode, then use option

02, 03, 04, 05 to set up IP address, Subnet Mask, Gateway and DNS server respectively.

 FIRMWARE SERVER IP ADDRESS

Select voice menu option 13 to configure the IP address of the firmware server.

 CONFIGURATION SERVER IP ADDRESS

Select voice menu option 14 to configure the IP address of the configuration server.

 UPGRADE PROTOCOL

Select the menu option 15 to choose firmware and configuration upgrade protocol between TFTP / HTTP.

 FIRMWARE UPGRADE MODE

Select voice menu option 17 to choose firmware upgrade mode among the following three options:

“Always check, check when pre/suffix changes, and never upgrade”.

The HT812/HT814 support 2 profiles which can be configured with 2 SIP accounts. Please refer to the

following steps in order to register your accounts via web user interface

1. Access your HT812/HT814 web UI by entering its IP address in your favorite browser.

2. Enter your admin password (default: admin).

3. Press Login to access your settings.

4. Go to Profile (1 or 2) pages.

5. In Profile tab, set the following:

a. Account Active to Yes.

b. Primary SIP Server field with your SIP server IP address or FQDN.

c. Failover SIP Server with your Failover SIP Server IP address or FQDN. Leave empty if not available.

d. Prefer Primary SIP Server to No or Yes depending on your configuration. Set to No if no Failover

SIP Server is defined. If “Yes”, account will register to Primary SIP Server when failover registration

expires.

e. Outbound Proxy: Set your Outbound Proxy IP Address or FQDN. Leave empty if not available.