Grandstream Networks, Inc. 126 Brookline Ave, 3rd Floor Boston, MA 02215 USA Voice: (617) 566-9300 Fax: (617) 249-1987 www.grandstream.com UCM630X IP PBX Appliance Quick Installation Guide For Certification, Warranty and RMA information, please visit www.grandstream.
Content English...............................................................................
EN The UCM630X is not pre-configured to support or carry PRECAUTIONS: emergency calls to any type of hospital, law enforcement agency, medical care unit (“Emergency Service(s)”) or any other kind of Emergency Service. You must make additional arrangements to access Emergency Services. It is your responsibility to purchase SIP-compliant Internet telephone service, properly configure the UCM630X to use that service, and periodically test your configuration to confirm that it works as you expect.
CONNECTING THE UCM630X: Reset LAN port FXS ports FXO ports Ground Rear view DC 12V WAN port Heartbeat port Front view SD Card slot USB ports • Press “Settings“ key to start browsing menu options. • Press “Navigation Key” to browse different menu options. Press “OK” to select an entry. • In the menu option, select “Back” to go back to previous menu. • The LCD will return to default display after being idle in menu for longer than 20 seconds. CONFIGURING THE UCM630X VIA WEB GUI: 1.
For certification information, please refer to User Manuals: http://www.grandstream.com U.S. FCC Part 68 Regulatory Information This equipment complies with Part 68 of the FCC rules. Located on the equipment is a label that contains, among other information, the ACTA registration number and ringer equivalence number (REN.) If requested, this information must be provided to the telephone company. The REN is used to determine the quantity of devices which may be connected to the telephone line.
U.S. FCC Part 15 Regulatory Information This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.