User Guide

GRP26XX Administration Guide
P a g e | 45
Do Not Disturb
(DND)—Off
Configures DND feature code to turn off DND.
Call Forward
Unconditionally (All)—
On
Configures Call Forward All feature code to activate unconditional call
forwarding.
Call Forward
Unconditionally (All)—
Off
Configures Call Forward All feature code to deactivate unconditional call
forwarding
Target
Configures the extension that the call will be forwarded to.
Call Forward Busy—
On
Configures Call Forward Busy feature code to activate busy call forwarding.
Call Forward Busy—
Off
Configures Call Forward Busy feature code to deactivate busy call
forwarding.
Target
Configures the extension that the call will be forwarded to.
Call Forward Delayed
(No Answer)—On
Configures Call Forward Delayed feature code to activate no answer call
forwarding.
Call Forward Delayed
(No Answer)—Off
Configures Call Forward Delayed feature code to activate no answer call
forwarding.
Target
Configures the extension that the call will be forwarded to.
Delayed Call Forward
Wait Time
Defines the timeout (in seconds) before the call is forwarded on no answer.
The default value is 20 seconds. The valid range is 1 to 120.
Accounts → Account Swap
Swap Account
Settings
Allows users to swap the two accounts that they have configured. This will
Increase the flexibility of account management.
Note: Make sure to press “Start” to complete the process.
Settings Page Definitions
Table 9: Settings Page Definitions
Settings → General Settings
Local RTP Port
This parameter defines the local RTP port used to listen and transmit. It is
the base RTP port for channel 0. When configured, channel 0 will use this
port _value for RTP; channel 1 will use port_value+2 for RTP. Local RTP
port ranges from 1024 to 65400 and must be even. Default value is 5004.
Local RTP Port Range
Gives users the ability to define the parameter of the local RTP port used to
listen and transmit. This parameter defines the local RTP port from 48 to
10000. This range will be adjusted if local RTP port + local RTP port range
is greater than 65486. Default setting is 200.