User Guide

GRP26XX Administration Guide
P a g e | 75
VLAN to configure VLAN tag and priority. Default is “Enabled”.
Layer 2 QoS
802.1Q/VLAN Tag
Assigns the VLAN Tag of the Layer 2 QoS packets. The default value is 0.
Layer 2 QoS 802.1p
Priority Value
Assigns the priority value of the Layer2 QoS packets. The default value is 0.
PC Port Mode
Configure the PC port mode. When set to “Mirrored”, the traffic in the LAN
port will go through PC port as well and packets can be captured by
connecting a PC to the PC port. The default setting is “Enabled”.
PC Port VLAN Tag
Assigns the VLAN Tag of the PC port. The default value is “0”.
PC Port Priority Value
Assigns the priority value of the PC port. The default value is “0”.
Enable CDP
Enables/Disables CDP “Cisco Discovery Protocol”.
Enable LLDP
Controls the LLDP (Link Layer Discovery Protocol) service. The default
setting is “Enabled”.
LLDP TX Interval
Defines LLDP TX Interval (in seconds). Valid range is 1 to 3600.
Maximum
Transmission Unit
(MTU)
Defines the MTU in bytes. Default is 1500 bytes.
Network → Remote Control
Action URI Support
Enable/disabled action URI feature on the phone.
Remote control Pop
up window support
Indicates whether the phone is enabled to pop up allow remote control.
Action URI allowed IP
list
List of allowed IP address from which the phone receives action URI. The
Allowed IP addresses are separated by a comma such as
“192.168.1.1,192.168.1.2”. Set this field to “any” to allow any IP address to
send Action URL to the phone. The default value is empty string which
means no IP address is allowed for remotely control the phone.
CSTA Control
Indicates whether CSTA Control feature is enabled. Change of this
configuration will need the system to reboot to take effect.
Network → Affinity Settings
Affinity Support
Allows communication with GS Affinity CTI application to manage telephone
calls from computer. If enabled, a reboot is required to establish the
communication. Default is “Disabled”.
GS Affinity CTI Application is available HERE and its User Guide HERE.
Preferred Account
Selects the account on which CTI support is enabled.
Network → Bluetooth Settings
Bluetooth Power
Configures Bluetooth to power on, off or off with hiding menu from LCD.
Default setting is “On”.