User Guide
P a g e | 107
GWN7000 User Manual
Version 1.0.4.23
Figure 71: Access File Share
SNMP
GWN7000 supports SNMP (Simple Network Management Protocol) which is widely used in network
management for network monitoring for collecting information about monitored devices.
To configure SNMP settings, go to GWN7000 Web GUISystem SettingsSNMP, this page has two
tabs: Basic and Advanced, refer to the below tables for each tab.
Table 45: SNMP Basic Page
System Location
Set the System Location information, for example: SNMP-Server Lobby GWN.
System Contact
Set the System Contact information, for example: Contact Supervisor_GWN via
extension is 1000.
System Name
Set the System Name information, for example: Supervisor_GWN.
Read-Only
Community for IPv4
Gives the permission for the set community to access and read only to devices in
management information base via IPv4 Protocol.
Read-Write
Community for IPv4
Gives the permission for the set community to access and read/write to devices in
management information base via IPv4 Protocol.
Read-Only
Community for IPv6
Gives the permission for the set community to access and read only to devices in
management information base via IPv6 Protocol.