User Guide

P a g e | 26
GWN7000 User Manual
Version 1.0.4.23
Preferred IPv6 DNS
This option appears only when “Native IPv6” option is enabled.
It is used to set a preferred DNS server address (IPv6 address). If Preferred DNS
is set, GWN7000 will use it in priority.
Alternate IPv6 DNS
This option appears only when “Native IPv6” option is enabled.
It is used to set an Alternate DNS server address (IPv6 address). If Preferred DNS
is set, GWN7000 will use it in when the Preferred DNS fails.
IPv6 Relay to LAN
This option appears only when “Native IPv6” option is enabled.
When enabled the GWN7000 will relay IPv6 address to LAN clients
Multi-WAN
These options are used when both WAN ports are enabled and using Failover
feature:
• Tracking IP
Configures the tracking IP(s). ICMP packets are being used to track the IP(s)
address(es). When the tracking fails, the GWN7000 will use the secondary
WAN port as failover. Default IP used is 8.8.8.8.
• Tracking Timeout (sec)
Configures tracking timeout in seconds. Default value is 2.
• Tracking Interval (sec)
Configures the track interval in seconds. Default value is 5.
• Bandwidth
Specifies the bandwidth for the port, e.g: “100k”, “1M” or “100M”.
VLAN Tagging
Used to enable VLAN tagging. If set to “0” the VLAN tagging will be disabled,
otherwise set a VLAN value between 5 and 4093. Default is 0.
Tunnel
Tunnel page is used to set IPv6 tunnels on WAN ports via IPv6 tunnel brokers service providers, this serves
the purpose of transferring IPv6 packets over IPv4 Network. It supports creating 6in4, 6rd and AICCU
tunnels. Please refer to below tables for each tunnel type.
Table 6: 6In4 Tunnels
WAN Interface
Choose the WAN port on which to setup the 6in4 tunnel.
MTU
Set the Maximum Transmission Unit value.
The valid range is 64-9000. Default value is 1500.
6in4 IPv4 Peer
Address
Enter the IPv4 tunnel endpoint at the tunnel’s provider.
6in4 Tunnel Endpoint
IPv6 Address
Enter the local IPv6 address delegated to the tunnel endpoint.
Example: 2001:db8:2222::2/64
6in4 Routed Prefix
Set the routable prefix given by the tunnel provider to allow LAN clients to get
addresses from that prefix.
Tunnel ID
Specifies the tunnel’s ID.
Username
Set the username used to login into the tunnel broker.