User Guide

P a g e | 27
GWN7000 User Manual
Version 1.0.4.23
Password
Set the password (used for endpoint update).
Update Key
Set the update key, it overrides the password used for endpoint update.
Table 7: 6rd Tunnels
WAN Interface
Choose the WAN port on which to setup the 6rd tunnel.
MTU
Set the Maximum Transmission Unit value.
The valid range is 64-9000 and default value is 1500.
6rd IPv4 Peer
Address
Enter the IPv4 Peer address.
6rd IPv6 Address
Prefix
Specifies the IPv6 prefix given by the provider.
Example: 2001:B000::/32
IPv6 Prefix Length
Specifies the IPv6 prefix length (Value between 1 and 128).
Example: 32
IPv4 Prefix Length
Specifies the prefix length of the IPv4 transport address.
(Value between 1 and 32).
Table 8: AICCU Tunnels
WAN Interface
Choose the WAN port on which to setup the aiccu tunnel.
Username
Enter the Username (Provided by signing up with SixXS Tunnel Broker)
Password
Enter the Username’s password
Global Settings
This section specifies operating mode for multi-WAN that will be used for enabling/disabling Failover and
Load Balancing on WAN ports, and banning MAC addresses.
The following table shows the configuration parameters for Multi-WAN settings
Table 9: GWN7000 WEB GUIRouterPortGlobal Settings
Multi-WAN
Specifies the operating mode for multi -WAN. Three options are available:
• Disabled
• Failover: Automatically switch to the connected WAN after failure.
• Load Balance + Failover: Operating the load balance mode, at the same
time automatically switch to the connected WAN after failure.
Disabled
This will disable Multi-WAN feature
Failover
If chosen failover will be enabled on WAN ports, admins need to choose the
Primary WAN port to be used.
When selected, user can set Multi-WAN parameters on WAN ports.