User Guide

P a g e | 38
GWN7000 User Manual
Version 1.0.4.23
• Radio Power: Set the Radio Power depending on desired cell
size to be broadcasted, three options are available: “Low”,
“Medium” or “High”. Default is “High”.
• Allow Legacy Device(802.11b): This feature appears when
“Mode” option is set to “802.11g” or “802.11n”, it allows legacy
devices not supporting “802.11g/n” mode to connect using the
“802.11b” mode.
• Custom Wireless Power(dBm): allows users to set a custom
wireless power for both 5GHz/2.4GHz band, the value of this field
must be between 1 and 31.
Access Point location
GWN7000 router has an interesting feature to help users to locate different access points using blinking
LED, to do so go under the access points page then click on button as shown on the below figure and the
corresponding LED will start blinking its LEDs. This can help ease locating the Access points on a multi-
deployment site.
Figure 16: locating Access Points
Note: If a GWN76xx is not being paired, or the pair icon is grey color, make sure that it is not being paired
with another GWN7000 Router or GWN76xx Access Point acting as Master Controller, if yes, it needs to
be unpaired first, or reset to factory default settings to make it available for pairing.
Network Groups
GWN7000 supports creating up to 16 different Network groups separated by VLANs and adding paired
GWN76xx Access Points.
To access Network Groups configuration page, log in to the GWN7000 WebGUI and go to Network
GroupNetwork Group.