User Guide

ManualsBrandsGrandstream ManualsComputers & AccessoriesGrandstream Enterprise Multi-WAN Gigabit VPN Router (GS-GWN7000)

P a g e | 40

GWN7000 User Manual

Version 1.0.4.23

• Basic: Used to name the network group, and set a VLAN ID if adding a new network group, and

addressing plans, refer to below table for each field.

Table 19: Basic

Network Group Name

Specifies the name for the network group.

Enabled

Check to activate the newly created network group.

WAN Membership

Select the WAN port membership. Or use Multi-WAN option if enabled

under RouterPortGlobal Settings

LAN Membership

Select the LAN port membership.

VLAN

Check to enable VLAN. This field is appearing only when having more than

a network group.

VLAN ID

Set a VLAN ID. Valid range is between 2 and 4093.

Enable IPv4

Check to enable IPv4 addressing for this network group

IPv4 Static Address

Set a static IPv4 address for the network group when enabling IPv4.

Additional IPv4 Static

Address

Set an additional static IPv4 address for the network group when enabling

IPv4.

IPv4 Subnet Mask

Set the Subnet Mask.

DHCP Enabled for IPv4

Check to enable DHCP using IPv4. This will allow clients connected to this

network group to get IPv4 addresses automatically from GWN7000 acting

as DHCP server.

DHCP Start Address

Set the starting IPv4 address for this network group’s clients.

DHCP End Address

Set the ending IPv4 address for this network group’s clients

DHCP Lease Time

Set the lease time for DHCP clients, the value can be defined in hours,

minutes, or as “infinite”. Default lease time is “12h”.

DHCP Options

Set the DHCP options. Click on to add another option, and to

delete an option.

Example: 44,192.168.2.50 for DHCP option 44 and 192.168.2.50 is the

WINS server’s address. Please refer to the following link for DHCP options

syntax: https://wiki.openwrt.org/doc/howto/dhcp.dnsmasq

DHCP Gateway

Defines the IP address of the DHCP gateway.

DHCP Preferred DNS

Set the preferred DNS Servers via DHCP.

DHCP Alternate DNS

Set the alternate DNS Servers via DHCP.

DHCPv4 Relay Enabled

Enable this option, if you want the GWN7000 relays the DHCP requests

from clients to another DHCP server(s). Once checked Click on to

add another DHCPv4 Relay Target, and to delete a DHCPv4 Relay

Target.