User Guide

P a g e | 43
GWN7000 User Manual
Version 1.0.4.23
Gateway MAC Address
This field is required when using Client Isolation, so users will not lose
access to the Network (usually Internet).
Type in the default LAN Gateway’s MAC address (router’s MAC address
for instance) in hexadecimal separated by “:”.
Example: 00:0B:82:8B:4D:D8
RSSI Enabled
Check to enable RSSI function, this will lead the AP to disconnect users
below the configured threshold in Minimum RSSI (dBm).
Minimum RSSI (dBm)
Enter the minimum RSSI value in dBm. If the signal value is lower than the
configured minimum value, the client will be disconnected. The input range
is from “-94” or “-1”.
Enable Voice Enterprise
Enable this feature to help clients of APs connected to the GWN7000 to
perform better roaming decision.
• The 802.11k standard helps clients to speed up the search for
nearby APs that are available as roaming targets by creating an
optimized list of channels. When the signal strength of the current
AP weakens, your device will scan for target APs from this list.
• When your client device roams from one AP to another on the
same network, 802.11r uses a feature called Fast Basic Service
Set Transition (FT) to authenticate more quickly. FT works with
both pre-shared key (PSK) and 802.1X authentication methods.
Enable 11R
Enable 11K
Enable 11V
11R, 11V, 11K respectively represents the feature sets the three protocols
802.11r, 802.11v, 802.11k specifies, enterprise audio is a function based
on these feature sets, and 11R is required, without this function, the
enterprise audio will be unavailable.
Upstream Rate
Set a limitation of upload speed on the SSID.
Downstream Rate
Set a limitation of download speed on the SSID.
• Device Membership: Used to add or remove paired access points to the network group.