User Guide

P a g e | 86
GWN7000 User Manual
Version 1.0.4.23
MSS Clamping
Check to enable MSS Clamping. This will provide a method to prevent
fragmentation when the MTU value on the communication path is lower
than the MSS value.
Log Dropped and Reject
Traffic to Syslog
Check to send all rejected and dropped traffic logs to configured Syslog
Server.
Limit for Dropped and
Rejected Traffic
Specify the limit for dropped and reject traffic. The value format is N/unit,
where N is a digit number, and unit can either be in second, minute, hour
or day.
SNAT
Following actions are available for SNAT.
• To add new SNAT entry, click on .
• To edit a SNAT entry, click on .
• To delete a SNAT rule, click on .
Refer to below table when creating or editing an SNAT entry
Table 35: SNAT
Name
Specify a name for the SNAT entry
Enabled
Check to enable this SNAT entry.
IP Family
Select the IP version, three options are available: IPv4, IPv6 or Any.
Source Group
Select a WAN interface or a LAN group for Source Group, or select All.
Destination Group
Select a WAN interface or a LAN group for Destination Group, or select
All. Make sure that destination and source groups are different to avoid
conflict.
Protocol
Select one of the protocols from dropdown list or All, available options
are: UDP, TCP, TCP/UCP and All.
Source IP
Set the Source IP address.
Rewrite IP
Set the Rewrite IP. The source IP address of the data package from the
source group will be updated to this configured IP.
Destination IP
Set the Destination IP address.
Schedule Start Date
Click on icon to schedule a start date for this SNAT entry to be
applied.
Schedule End Date
Click on icon to schedule an end date for this SNAT entry to end.