User Guide

P a g e | 96
GWN7000 User Manual
Version 1.0.4.23
Upgrade Now
Click on Upgrade, to launch firmware/config file provisioning.
Please make sure to Save and Apply changes before clicking on Upgrade.
Factory Reset
Click on Reset to restore the GWN7000 as well as all online GWN76xx units
to factory default settings
Access
Current Administrator
Password
Enter the current administrator password
New Administrator
Password
Change the current password. This field is case sensitive with a maximum
length of 32 characters.
Confirm New
Administrator Password
Enter the new administrator password one more time to confirm.
User Password
Configure the password for user-level Web GUI access. This field is case
sensitive with a maximum length of 32 characters.
User Password
Confirmation
Enter the new User password again to confirm.
Syslog
Syslog Server
Enter the IP address or URL of Syslog server. Please reboot the GWN7000
to take effect.
Syslog Level
Select the level of Syslog, 5 levels are available: None, Debug, Info,
Warning and Error. Please reboot the GWN7000 to take effect.
Logserver
The logserver page allows the user to configure syslog server on GWN7000 in order to save log messages
on connected external USB drive.
First connect a USB drive to the Access point, then configure the parameters and make sure to start the
server in order to collect messages from devices sending syslog to GWN.
Following table gives description for configuration parameters of GWN Logserver:
Option
Description
Enable WAN Firewall Rule
Enable WAN Firewall rules to allow incoming syslog messages to the router.
Logrotate File Size
Select the size of file to trigger rotation, if left empty, then the router will use
only the Logrotate frequency rules to trigger rotation.
Logrotate File Count
Select the Maximum number of rotates files to keep. Default is 56 files.
Logrotate Mode
Choose the time rotation frequency mode (default every 3 hours).
• Every X hours (0-23)
• Every X Minutes (0-59).