User Guide
Table Of Contents
- DOCUMENT PURPOSE
- CHANGE LOG
- GUI INTERFACE EXAMPLES
- WELCOME
- PRODUCT OVERVIEW
- GETTING STARTED
- CONFIGURATION GUIDE
- Obtain HT801/HT802 IP Address via Connected Analogue Phone
- Understanding HT801/HT802 Interactive Voice Prompt Response Menu
- Configuration via Web Browser
- NAT Settings
- DTMF Methods
- Preferred Vocoder (Codec)
- Configuring the HT801/HT802 Through Voice Prompts
- Register a SIP Account
- Rebooting the HT801/HT802 from Remote
- CALL FEATURES
- CALL OPERATIONS
- RESTORE FACTORY DEFAULT SETTINGS
- EXPERIENCING HT801/HT802
P a g e | 23
HT801/HT802 User Guide
Version 1.0.5.11
Preferred Vocoder (Codec)
The HT801/HT802 supports following voice codecs. On FXS ports pages, choose the order of your favorite
codecs:
• PCMU/A (or G711µ/a)
• G729 A/B
• G723.1
• G726
• iLBC
• OPUS
Configuring the HT801/HT802 Through Voice Prompts
As mentioned previously, The HT801/HT802 has a built-in voice prompt menu for simple device
configuration. Please refer to “Understanding HT801/HT802 Interactive Voice Prompt Response Menu” for
more information about IVR and how to access its menu.
• DHCP MODE
Select voice menu option 01 to allow the HT801/HT802 to use DHCP.
• STATIC IP MODE
Select voice menu option 01 to allow the HT801/HT802 to enable the STATIC IP mode, then use option
02, 03, 04, 05 to set up IP address, Subnet Mask, Gateway and DNS server respectively.
• FIRMWARE SERVER IP ADDRESS
Select voice menu option 13 to configure the IP address of the firmware server.
• CONFIGURATION SERVER IP ADDRESS
Select voice menu option 14 to configure the IP address of the configuration server.
• UPGRADE PROTOCOL
Select the menu option 15 to choose firmware and configuration upgrade protocol between TFTP, HTTP
and HTTPS. Default is HTTPS.
• FIRMWARE UPGRADE MODE
Select voice menu option 17 to choose firmware upgrade mode among the following three options:
“Always check, check when pre/suffix changes, and never upgrade”.