Grandstream Networks, Inc. 126 Brookline Ave, 3rd Floor Boston, MA 02215. USA Tel : +1 (617) 566 - 9300 Fax: +1 (617) 249 - 1987 www.grandstream.com GWN7800 Series For Certification, Warranty and RMA information, please visit www.grandstream.
EN OVERVIEW The GWN7800 series are Layer 2+ managed network switches that allow small-to-medium enterprises to build scalable, secure, high performance, and smart business networks that are fully manageable. It supports advanced VLAN for flexible and sophisticated traffic segmentation, advanced QoS for automated detection & prioritization of latency sensitive voice/video traffic, IGMP Snooping for network performance optimization, and comprehensive security capabilities against potential attacks.
GWN7803/GWN7803P GWN7802/GWN7802P 1 1 5 3 6 7 5 3 6 7 4 2 2 4 9 GWN7803 8 9 8 GWN7802 10 10 9 8 9 8 GWN7802P No. Port & LED Description 1 Port 1-16 16x Ethernet RJ45 (10/100/1000Mbps), used for connecting terminals. Note: GWN7802P Ethernet ports support PoE and PoE+.
LED Indicator LED Indicator System Indicator Port Indicator Status Description Off Power off Solid green Booting Flashing green Upgrade Solid blue Normal use Flashing blue Privisioning Solid red Upgrade failed Flashing red Factory reset Off • For all ports, port off • For SFP ports, port failure Solid green Port connected and there is no activity Flashing green Port connected and data is transferring Solid yellow Ethernet port connected and PoE powered Flashing yellow Ethernet po
2. After plugging the power cord into the power outlet, slide the protector over the remaining strap until it slides over the end of the power cord. Connect to SFP Port The installation process of the fiber module is as follows: 1. Grasp the fiber module from the side and insert it smoothly along the switch SFP port slot until the module is in close contact with the switch. SFP port Fiber module 3. Wrap the strap of the protective cord around the power cord and lock it tightly.
Connect to Console Port Install on the Wall 1. Connect the RJ45 end of the console cable to the console port of switch. 1. Use the matching screws (KM 3*6) to fix the two L-shaped rackmounting kits (rotated 90°) on both sides of switch. 2. Connect the other end of the console cable to the DB9 male connector or USB port to the PC. 2. Stick the switch port up and horizontally on the selected wall, mark the position of the screw hole on the L-shaped rack-mounting kits with a marker.
3. Type the switch’s default management IP address http://192.168.0.254 in the browser, and enter username and password to login(The default administrator username is “admin” and the default random password can be found at the sticker on the GWN7800 switch) 3. Place the switch in a proper position in the rack and support it by the bracket. 4.
U. S. FCC Part 15 Regulatory Information This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
