User's Manual
Table Of Contents
- CHANGE LOG
- WELCOME
- GATEWAY GXW450X OVERVIEW
- GETTING STARTED
- SYSTEM STATUS
- SYSTEM SETTINGS
- TRUNKS
- PBX SETTINGS
- MAINTENANCE
- CDR (Call DETAIL RECORD)
- EXPERIENCING THE GXW450X SERIES DIGITAL GATEWAY
Page | 22
GXW450X User Manual
Version 1.0.0.6
page. After the test, reboot the device manually and the device will display
the correct time.
• Hardware Testing
Select “Test DSP” to perform DSP test on the device.
This is mainly for factory testing purpose which verifies the hardware
connection inside the device. The diagnostic result displays on the LCD
after the test is done.
Default Password
Showing the
default Web login password. Once the password was changed,
this menu will not show again.
Web Info
• Protocol: Web access protocol. HTTP or HTTPS. By default, it’s HTTPS
• Port: Web access port number. By default, it’s 8089
SSH Switch
• Enable SSH: Enable SSH access.
• Disable SSH: Disable SSH access.
By default, the SSH access is disabled.
Use the LED Indicators
The GXW450X has LED indicators in the front to display connection status. The following table shows the
status definitions.
Table 5: GXW450X LED Indicators
LED Indicator LED Status
Power
LAN
WAN
Solid: Connected
OFF: Disconnected
T1/E1/J1
Solid: Connected and working
Blinking: No cable is connected; or connected
but the link is not working at all.