User's Manual

Page | 41
GXW450X User Manual
Version 1.0.0.6
IPv6 subnet - 2001:740:D::1/64
Netmask
Configure the subnet mask for the above
destination address. If left
blank, the default value is 255.255.255.255.
Example: 255.255.255.0
Gateway
Configure the IPv4 or IPv6 gateway address so that the GXW450X can
reach the destination via this gateway. Gateway address is optional.
Example:
192.168.40.5 or 2001:740:D::1
Interface
Specify the network interface on the GXW450X to reach the destination
using the static route.
OpenVPN®
OpenVPN® settings allow the users to configure GXW450X to use VPN features, the following table
gives details about the various options in order to configure the GXW450X as OpenVPN Client.
Table 10: GXW450X System SettingsNetwork SettingsOpenVPN®
OpenVPN® Enable
Enable / Disable the OpenVPN feature.
OpenVPN® Server
Configures the
hostname/IP and port of the server. For example,
"192.168.1.2:22" or "2001:0DB8:0000:0000:0000:0000:1428:0000".
OpenVPN® Server Protocol
Select the same protocol that the OpenVPN® server is using, e.g.,
select UDP if the OpenVPN® is using UDP.
OpenVPN® Device Mode
Use the same setting as used on the server. Dev TUN: Create a
routed IP tunnel. Dev TAP: Create an Ethernet tunnel.
OpenVPN® Use Compression
Compress tunnel packets using the LZO algorithm on the VPN link.
Don’t enable this unless it is also enabled in the server config file.
OpenVPN® Encryption
Algorithm
Please select a cryptographic cipher. Use the same setting that you
are using on the server.
OpenVPN® CA Cert
Upload a SSL/TLS root certificate. This file will be renamed as