User's Manual

Page | 69
GXW450X User Manual
Version 1.0.0.6
• NI2: National ISDN type 2 (common in the US)
• DMS100: Nortel DMS100
• 4ESS: AT&T 4ESS
• 5ESS: Lucent 5ESS
• NI1: old national ISDN type 1
• Q.SIG
PRI Dial Plan
This setting is used to specify the type of the callee number. The service
provider will usually verify this. The default setting is “unknown”. In some
very unusual circumstances, you may
need set to “Dynamic” or
“Redundant”.
Note: When one type is selected, you might not be able to dial another
class of numbers. For example, if “National” is configured, you won’t be
able to dial local or international numbers.
PRI Local Dial Plan
This se
tting is used to specify the type of the caller number. The service
provider will usually verify this.
International Prefix
National Prefix
Local Prefix
Private Prefix
Unknown Prefix
Configure the prefix in PRI Local Dial Plan and PRI Dial Plan for each
type.
PRI T310
Configure PRI T310 Timer (in seconds). The default value is 10 seconds.
PRI Indication
Select the PRI Indication.
• outofband: Use RELEASE, DISCONNECT or other messages with
CAUSE to indicate call progress (e.g., cause: unassigned number or
user busy).
• inband: use in-
band tones to play busy or congestion signal to the
other side. This is the default setting.
Reset Interval
The interval that restarts idle channels.
PRI Exclusive
This setting is used to set up the ChannelD
in SETUP message. If
enabled, only the specified B channel can be used. Otherwise, select one
of the channels in B channel. If you need override the existing channels
selection routine and force all PRI channels to be marked as exclusively