User's Manual

Page | 78
GXW450X User Manual
Version 1.0.0.6
PRI: when one end is set to NET, the other end should be set to CPE
Data channel
Chooses the Data Channel for control.
SS7 Variant
Select ITU, ANSI or CHINA.
Originating Point Code
Originating point code is used to identify the node originating the
message, always provided by the operator/ISP.
• ITU Format: decimal number.
• ANSI & CHINA Format: decimal number or XXX-XXX-XXX.
Destination Point Code
Destination point code is the address to send the message to, always be
provided by the operator/ISP.
• ITU Format: decimal number.
• ANSI & CHINA Format: decimal number or XXX-XXX-XXX.
First CIC
When Span Type is E1, ITU & CHINA Range: [0, 4065], ANSI Range: [0,
16353].
When Span Type is T1/J1, ITU & CHINA Range: [0,4072], ANSI Range:
[0, 16360].
Assign CIC to D-Channel
If set to yes, D-channel will be assigned with a CIC. Else, D-channel will
not be assigned with a CIC. By default, it is set to No.
Network Indicator
Network Indicator (NI) should match in nodes, otherwise it might cause
issues. Users can select "National", "National Spare", "International", or
"International Spare". Usually "National" or "International" is used.
LBO
The line build-out (LBO) is the distance between the operators and the
gateway. Please use the default value 0dB unless the distance is long.
Coding
T1:"AMI" or "B8ZS"
E1:"AMI" or "HDB3"
RX Gain
Configure the RX gain for the receiving channel of digital port. The valid
range is from -24dB to +12dB.