User's Manual

Page | 79
GXW450X User Manual
Version 1.0.0.6
TX Gain
Configure the TX Gain for the transmitting channel of digital port. The valid
range is -24dB to +12dB.
Codec
Select alaw or ulaw. If set to default, ulaw will be used for T1/J1.
Framing
Select “esf” or “d4”. Default setting is esf.
Advanced Settings
Called Nature of Address
Indicator
Indicates the type of the called number. The receiving switch may use this
indicator during translations to apply the number’s proper dial plan. Users
can select "Unknown", "Subscriber", "National", "International" or
"Dynamic".
Calling Nature of Address
Indicator
Indicates the type of the calling number. The receiving switch may use this
indicator during translations to apply the number’s proper dial plan. Users
can select "Unknown", "Subscriber", "National", "International" or
"Dynamic".
International Prefix
National Prefix
Subscriber Prefix
Unknown Prefix
Configure the prefix in Called Nature of Address Indicator and Calling
Nature of Address Indicator for each type.
Digital Trunk Configuration
After configuring digital hardware, go to Web GUI TrunksDigital Trunks.
• Click on to add a new digital trunk.
• Click on to configure detailed parameters for the digital trunk.
• Click on to delete the digital trunk.
The digital trunk parameters are listed in the table below.
Table 27: Digital Trunk Configuration Parameters
Trunk Name
Configure trunk name to identify the digital trunk.