User's Manual
Table Of Contents
- CHANGE LOG
- WELCOME
- GATEWAY GXW450X OVERVIEW
- GETTING STARTED
- SYSTEM STATUS
- SYSTEM SETTINGS
- TRUNKS
- PBX SETTINGS
- MAINTENANCE
- CDR (Call DETAIL RECORD)
- EXPERIENCING THE GXW450X SERIES DIGITAL GATEWAY
Page | 92
GXW450X User Manual
Version 1.0.0.6
Session Timer
Table 31: SIP Settings/Session Timer
Force Timer
If checked, always request and run session timer.
Timer
If checked, run session timer only when requested by another UA.
Session Expire
Configure the maximum session refresh interval (in seconds).
The default setting is 1800.
Min SE
Configure the minimum session refresh interval (in seconds).
The default setting is 90.
TCP and TLS
Table 32: SIP Settings/TCP and TLS
TCP Enable
Configure to allow incoming TCP connections with the GXW450X
. The
default setting is "No".
TCP Bind IPv4 Address
Configure the IP address for TCP server to bind to. 0.0.0.0 means binding
to all interfaces. The port number is optional. If not specified, 5060 will be
used.
TCP Bind IPv6 Address
Configure the IPv6 address for TCP server to bind to. "[::]" means bind to
all interfaces. The port number is optional with the default being 5060. For
example, [2001:0DB8:0000:0000:0000:0000:1428:0000]:5060.
TLS Enable
Configure to allow incoming TLS connections with the GXW450X
. The
default setting is "No".
TLS Bind IPv4 Address
Configure the IP address for TLS server to bind to. 0.0.0.0 means binding
to all interfaces. The port number is optional. If not specified, 5061 will be
used.
Note:
The IP address must match the common name (hostname) in the
certificate. Please do not bind a TLS socket to multiple IP addresses. For
details on how to construct a certificate for SIP, please refer to the
following document:
http://tools.ietf.org/html/draft-ietf-sip-domain-certs