Data sheet

P a g e | 137
UCM6200 Series User Manual
Version 1.0.19.27
Fax Mode
Select Fax Mode. The default setting is “None”.
• None: Disable Fax. This is the default setting.
• Fax Detect: Fax signal from the user/trunk during the call can be detected and
the received Fax will be sent to the Email address configured for this extension.
If no Email address can be found for the user, the Fax will be sent to the default
Email address configured in Fax setting page under Web GUI→Call
Features→Fax/T.38.
Strategy
This option controls how the extension can be used on devices within different types
of network.
• Allow All
Device in any network can register this extension.
• Local Subnet Only
Only the user in specific subnet can register this extension. Up to three subnet
addresses can be specified.
• A Specific IP Address
Only the device on the specific IP address can register this extension.
The default setting is "Allow All".
Codec Preference
Select audio and video codec for the extension. The available codecs are: PCMU,
PCMA, GSM, AAL2-G.726-32, G,726, G.722, G.729, G.723, iLBC, ADPCM, H.264,
H.265, H.263, H.263p, RTX and VP8.
Table 38: IAX Extension Configuration Parameters→Features
Call Transfer
Call Forward
Unconditional
Configure the Call Forward Unconditional target number. If not configured, the Call
Forward Unconditional feature is deactivated.
The default setting is deactivated.
CFU Time
Condition
Select time condition for Call Forward Unconditional. CFU takes effect only during the
selected time condition. The available time conditions are “Office Time”, “Out of Office
Time”, “Holiday”, “Out of Holiday”, “Out of Office Time or Holiday” and “Specific”.
Note:
• “Specific” has higher priority to “Office Times” if there is a conflict in terms of time
period.
• Specific time can be configured on the bottom of the extension configuration
dialog. Scroll down the add Time Condition for specific time.
• Office Time and Holiday could be configured on page System Settings→Time
Settings→Office Time/Holiday page.
Call Forward No
Answer
Configure the Call Forward No Answer target number. If not configured, the Call
Forward No Answer feature is deactivated. The default setting is deactivated.