Data sheet

P a g e | 144
UCM6200 Series User Manual
Version 1.0.19.27
Skip Trunk Auth
• If set to “Yes”, users can skip entering the password when making outbound calls.
• If set to “By Time”, users can skip entering the password when making outbound
calls during the selected time condition.
• If set to “No”, users will be asked to enter the password when making outbound
calls.
Time Condition for
Skip Trunk Auth
If “Skip Trunk Auth” is set to “By Time”, select a time condition during which users can
skip entering password when making outbound calls.
Dial Trunk
Password
Configure personal password when making outbound calls via trunk.
Enable LDAP
If enabled, this extension will be added to LDAP Phonebook PBX list; if disabled, this
extension will be skipped when creating LDAP Phonebook.
Music On Hold
Select which Music On Hold class to suggest to extension when putting the active call
on hold.
Call Duration Limit
Configure the maximum duration of call-blocking.
Table 43: FXS Extension Configuration Parameters→Specific Time
Specific Time
Time Condition
Click to add Time Condition to configure specific time for this extension.
Batch Add Extensions
Batch Add SIP Extensions
To add multiple SIP extensions, BATCH add can be used to create standardized SIP extension accounts.
However, unique extension user name can’t be set using BATCH add.
Under Web GUI→Extension/Trunk→Extensions, click on "Add” and select extension type as SIP extension,
and “add method” as Batch.
Table 44: Batch Add SIP Extension Parameters
General
Create Number
Specify the number of extensions to be added. The default setting is 5.
Extension
Incrementation
Select how much to increment successive extensions. For example, if the value is 2,
the extensions will be 1000,1002,1004,...... Note: Up to 3 characters.
Extension
Configure the starting extension number of the batch of extensions to be added.
Permission
Assign permission level to the user. The available permissions are "Internal", "Local",
"National" and "International" from the lowest level to the highest level. The default
setting is "Internal".
Note: Users need to have the same level as or higher level than an outbound rule's
privilege to make outbound calls from this rule.