User Manual

P a g e | 123
UCM6200 Series User Manual
Version 1.0.15.16
Select first which type of extension: SIP Extension, IAX Extension or FXS Extension. The configuration
parameters are as follows.
Table 31: SIP Extension Configuration ParametersBasic Settings
General
Extension
The extension number associated with the user.
CallerID Number
Configure the CallerID Number that would be applied for outbound calls from this
user.
Note:
The ability to manipulate your outbound Caller ID may be limited by your VoIP
provider.
Permission
Assign permission level to the user. The available permissions are "Internal", "Local",
"National" and "International" from the lowest level to the highest level. The default
setting is "Internal".
Note:
Users need to have the same level as or higher level than an outbound rule's privilege
to make outbound calls using this rule.
SIP/IAX Password
Configure the password for the user. A random secure password will be automatically
generated. It is recommended to use this password for security purpose.
Auth ID
Configure the authentication ID for the user. If not configured, the extension number
will be used for authentication.
Enable Voicemail
Enable voicemail for the user. The default setting is "Yes".
Voicemail
Password
Configure voicemail password (digits only) for the user to access the voicemail box.
A random numeric password is automatically generated. It is recommended to use
the random generated password for security purpose.
Skip Voicemail
Password
Verification
When user dials voicemail code, the password verification IVR is skipped. If enabled,
this would allow one-button voicemail access. By default, this option is disabled.
Send Voicemail to
Email
Allows users to send voicemail recording as .wav file attachment to specified email
addresses. Default setting is “No”.
Note: When set to “Default”, the global settings in Call Features  Voicemail 
Voicemail Email Settings will be used.
Keep Voicemail
after Emailing
Whether to keep the local voicemail recording after sending them. If set to “Default”,
the global settings will be used.
Note: When set to “Default”, the global settings in Call Features  Voicemail 
Voicemail Email Settings will be used.
Enable Keep-alive
If enabled, empty SDP packet will be sent to the SIP server periodically to keep the
NAT port open. The default setting is "Yes".
Keep-alive
Frequency
Configure the Keep-alive interval (in seconds) to check if the host is up. The default
setting is 60 seconds.