User Manual

P a g e | 136
UCM6200 Series User Manual
Version 1.0.15.16
Enable Polarity
Reversal
If enabled, a polarity reversal will be marked as received when an outgoing call is
answered by the remote party. For some countries, a polarity reversal is used for
signaling the disconnection of a phone line and the call will be considered as Hangup
on a polarity reversal. The default setting is "Yes".
Echo Cancellation
Specify "ON", "OFF" or a value (the power of 2) from 32 to 1024 as the number of
taps of cancellation.
Note: When configuring the number of taps, the number 256 is not translated into
256ms of echo cancellation. Instead, 256 taps mean 256/8 = 32 ms. The default
setting is "ON", which is 128 taps.
3-Way Calling
Configure to enable/disable 3-way calling feature on the user. The default setting is
enabled.
Send CallerID
After
Configure the number of rings before sending CID. Default setting is 1.
Fax Mode
For FXS extension, there are three options available in Fax Mode. The default setting
is “None”.
• None: Disable Fax.
• Fax Detect: Fax signal from the user/trunk during the call can be detected and
the received Fax will be sent to the Email address configured for this extension.
If no Email address can be found for the user, the Fax will be sent to the default
Email address configured in Fax setting page under Web GUICall
FeaturesFax/T.38.
• Fax Gateway: If selected, the UCM6200 can support conversation and
processing of Fax data from T.30 to T.38 or T.38 to T.30. only for FXS ports.
Table 41: FXS Extension Configuration ParametersFeatures
Call Transfer
Call Forward
Unconditional
Configure the Call Forward Unconditional target number. If not configured, the Call
Forward Unconditional feature is deactivated. The default setting is deactivated.
CFU Time
Condition
Select time condition for Call Forward Unconditional. CFU takes effect only during the
selected time condition. The available time conditions are “Office Time”, “Out of Office
Time”, “Holiday”, “Out of Holiday”, “Out of Office Time or Holiday” and “Specific”.
Note:
• “Specific” has higher priority to “Office Times” if there is a conflict in terms of time
period.
• Specific time can be configured on the bottom of the extension configuration
dialog. Scroll down the add Time Condition for specific time.
• Office Time and Holiday could be configured on page System SettingsTime
SettingsOffice Time/Holiday page.
Call Forward No
Answer
Configure the Call Forward No Answer target number. If not configured, the Call
Forward No Answer feature is deactivated. The default setting is deactivated.