User Manual

P a g e | 142
UCM6200 Series User Manual
Version 1.0.15.16
• Local Subnet Only
Only the user in specific subnet can register this extension. Up to three subnet
addresses can be specified.
• A Specific IP Address
Only the device on the specific IP address can register this extension.
Enable T.38
UDPTL
Enable or disable T.38 UDPTL Support.
Skip Trunk Auth
If enable “All”, users do not need to enter password when making an outbound call. If
enable “Follow Me”, the user can dial out via follow me without password.
Codec Preference
Select audio and video codec for the extension. The available codecs are: PCMU,
PCMA, GSM, AAL2-G.726-32, G.722, G.729, G.723, Ilbc, ADPCM, LPC10, H.264,
H.263, H.263p and VP8.
Batch Add IAX Extensions
Under Web GUIExtension/TrunkExtensions, click on “Add”, then select extension type as IAX Extension
and the add method to be Batch.
Table 44: Batch Add IAX Extension Parameters
General
Start Extension
Configure the starting extension number of the batch of extensions to be added.
Create Number
Specify the number of extensions to be added. The default setting is 5.
Permission
Assign permission level to the user. The available permissions are “Internal”, “Local”,
“National” and “International” from the lowest level to the highest level. The default
setting is “Internal”.
Note: Users need to have the same level as or higher level than an outbound rule’s
privilege in order to make outbound calls from this rule.
Enable Voicemail
Enable Voicemail for the user. The default setting is “Yes”.
SIP/IAX Password
Configure the SIP/IAX password for the users. Three options are available to create
password for the batch of extensions.
• User Random Password.
A random secure password will be automatically generated. It is recommended
to use this password for security purpose.
• Use Extension as Password.
• Enter a password to be used on all the extensions in the batch.
Voicemail
Password
Configure Voicemail password (digits only) for the users.
• User Random Password.
A random password in digits will be automatically generated. It is recommended
to use this password for security purpose.
• Use Extension as Password.
• Enter a password to be used on all the extensions in the batch.