User Manual

P a g e | 143
UCM6200 Series User Manual
Version 1.0.15.16
Ring Timeout
Configure the number of seconds to ring the user before the call is forwarded to
voicemail (voicemail is enabled) or hang up (voicemail is disabled). If not specified,
the default ring timeout is 60 seconds on the UCM6200, which can be configured in
the global ring timeout setting under Web GUIPBX SettingsVoice
PromptCustom Prompt: General Preference. The valid range is between 5
seconds and 600 seconds.
Note:
If the end point also has a ring timeout configured, the actual ring timeout used is the
shortest time set by either device.
Auto Record
Enable automatic recording for the calls using this extension. The default setting is
disabled. The recording files can be accessed under Web GUICDRRecording
Files.
Skip Voicemail
Password
Verification
When user dials voicemail code, the password verification IVR is skipped. If enabled,
this would allow one-button voicemail access. By default, this option is disabled.
Music On Hold
Select which Music On Hold class to suggest to extensions when putting them on
hold.
Enable LDAP
If enabled, the batch added extensions will be added to LDAP Phonebook PBX list;
if disabled, the batch added extensions will be skipped when creating LDAP
Phonebook.
Call Duration Limit
Configure the maximum duration of call-blocking.
IAX Settings
Max Number of Calls
Configure the maximum number of calls allowed for each remote IP address.
Require Call Token
Configure to enable/disable requiring call token. If set to "Auto", it might lock out
users who depend on backward compatibility when peer authentication credentials
are shared between physical endpoints.
The default setting is "Yes".
Other Settings
SRTP
Enable SRTP for the call. The default setting is "No".
Fax Mode
Select Fax Mode for this user. The default setting is “None”.
• None: Disable Fax.
• Fax Detect: Fax signal from the user/trunk during the call can be detected and
the received Fax will be sent to the Email address configured for this extension.
If no Email address can be found for the user, the Fax will be sent to the default
Email address configured in Fax setting page under Web GUICall
FeaturesFax/T.38.
Strategy
This option controls how the extension can be used on devices within different types
of network.