Administration Guide
P a g e | 57
WP820 Administration Guide
Version 1.0.5.5
Accept while busy
Defines whether to accept PTT calls while device is in active call.
• If set to "No", device will ignore PTT calls while in active call.
• If set to "Yes", while in active PTT call, device will accept PTT if it has the
same priority; If device is in active SIP call, device will accept PTT and put
the SIP call on hold.
Default is “No”
Caller ID
Set Caller ID displayed on the call interface during a PTT call.
PTime (ms)
Set payload size for PTT.
Audio codec
Selects the codec type for the PTT call. The list includes: G.722, G.711, Opus.
Channel
Defines PTT channel. Users can configure whether to use the channel for
“Available”, “Transmit”, “Subscribe” and “Join Channel” and its label. Only available
and joined channel will be displayed in PTT channel list. If users need send or
receive PTT, "Transmit" and "Available" must be enabled for this channel.
Paging Config
Group paging
Enable or disable group paging.
Default group
Defines default paging group. When pressing and holding the PTT button, paging
will be initiated using the default group.
Priority group
Defines priority paging group. Paging received on priority group will take
precedence over active paging on normal group.
Emergency group
Defines emergency group for paging. Emergency group has the highest priority.
Paging using emergency group will take precedence over paging on priority or
normal group. Please note paging to emergency group will not be rejected even
when device has enabled DND.
Accept while busy
Defines whether to accept paging while device is in active call.
• If set to "No", device will ignore paging while in active call.
• If set to "Yes", while in active paging call, device will accept paging if it has
the same priority; If device is in active SIP call, device will accept paging
and put the SIP call on hold.
Default is “No”.
Caller ID
Set Caller ID displayed on the call interface during paging
PTime (ms)
Set payload size for paging.
Audio codec
Selects the codec type for the paging call. The list includes: G.722, G.711, Opus.