Administration Guide

P a g e | 60
WP820 Administration Guide
Version 1.0.5.5
Add Network
ESSID
Determines the ESSID of the default Wi-Fi network. The default password is
“wp!987@dmin” and it uses WPA2PSK security access.
Security Mode for
Hidden SSID
This parameter defines the security mode used for the wireless network when the
SSID is hidden.
Password
Configures the hidden ESSID password.
Advanced Settings
Country Code
Configures Wi-Fi country code. The default value is "United States of America".
Note: Reboot is requested to take effect.
Host Name (Option
12)
Specifies the name of the client. This field is optional but may be required by some
Internet Service Providers.
Vendor Class ID
(Option 60)
Used by clients and servers to exchange vendor class ID.
Channel Mode
"Auto" mode is enabled by default, in this mode, devices will do fully scanning;
"Customize" mode is used to specify channels, and only the selected channels will
be scanned and used to make network switch and roaming decision.
Wi-Fi Roaming
Signal Threshold
Sets the Wi-Fi signal threshold. When the Wi-Fi signal strength of the device drops
below this configured value, the device will scan for a hotspot above the threshold
value and connect to it. The default setting is -70 and the valid range is [-100, -30].
Good Signal
Scanning Interval (s)
Sets the time interval for signal scanning when the Wi-Fi signal strength is higher
than the signal threshold. Default is 600s, and valid range is from 5 to 600.
Poor Signal
Scanning Interval (s)
Sets the time interval for signal scanning when the Wi-Fi signal strength is lower
than the signal threshold and there is no hotspot which is higher than the current
signal strength. Default is 5s, and valid range is from 5 to 600.
Network Settings/OpenVPN® Settings
Enable OpenVPN®
Enables/disables OpenVPN® functionality and requires the user to have access
to an OpenVPN® server.
Note: To use OpenVPN® functionalities, users must enable OpenVPN® and
configure all of the settings related to OpenVPN®, including server address, port,
OpenVPN® CA, certificate and key. Additionally, the user must also set the SIP
account to use "VPN" for the "NAT Traversal" (under Account → Network Settings).