Administration Guide

P a g e | 82
WP820 Administration Guide
Version 1.0.5.5
Value-added Service Page Definitions
Value-added Service
Door System Type
Configures the door system type. Each GDS door system has 2 different
access system.
Door System Name
Display info on LCD when incoming call matches GDS number. This is used
to identify door position, e.g:"east gate" or "3rd floor gate".
System Number
Password
Enables open door button display when caller number or IP address matches
this setting. e.g:"36311" or "192.168.124.81"
System Password
Configures the access password of the door system. This password
corresponds to the system number. When a call comes from the door system,
tap on the open button on LCD to send the password to the corresponding
door system.
System ringtone
Sets the system ringtone when receiving calls from GDS.
SAFE/Panic Call
SAFE Monitoring
Settings
When enabled, the phone can detect personal SAFE state.
No Movement Sensitivity
Configures the sensitivity of “No movement” detection. There are 7 levels
available for detection. Choose Disabled to stop No movement detection.
No Movement Timeout
Set the timeout value for “No movement” detection. The phone will start
warning if the phone keeps no movement until timeout.
Tilt Sensitivity
Set the sensitivity of Tilt detection. There are 7 levels available for detection.
Choose Disabled to stop Tilt detection.
Tilt Timeout
Set the timeout value for Tilt detection. The phone will start warning if the
phone keeps tilt until timeout.
Running Sensitivity
Set the sensitivity of Running detection. There are 7 levels available for
detection. Choose Disabled to stop Running detection.
Running Timeout
Set the timeout value for Running detection. The phone will start warning if
the phone keeps waggle until timeout.
Snooze Timeout
Set the timeout value of snooze. You can choose snooze while in
warning/alarm State. After the timeout, the phone will start detect again.