User`s manual

antenna/cable. Each TV varies slightly, so you may need to refer to

your TV's user's manual for further assistance.

8. If you are experiencing any distortion or interference in the

wireless transmission, change the transmission channels. Using a

paperclip, change the switches on both the transmitter and the

receiver so that they are on the same channel. Only one switch

should be DOWN on each and the switch that is DOWN indicates

which channel is in use.

9. If your TV does not have a VIDEO input, you may connect

through a VCR's VIDEO IN. Note: Since virtually every VCR is

different, please refer to your VCR User's Manual for exact

instructions for recording an external video source.

To connect the Grand Ultimate Wireless to a VCR for recording,

follow these steps:

1. Using either the RCA or the S-video (recommended) cable,

connect from the video out on the Grand Ultimate Wireless to the

Video IN on the VCR

2. Using either an RCA or a 75 Ohm coaxial cable connect from the

Video OUT on the VCR to the Video IN on the TV

3. Set the TV/VCR switch on the VCR to "VCR"

4. Set the TV to display the video input signal (Refer to TV's User's

manual for instruction on displaying an external video source)

5. You should be able to see the converted computer display on the

6. Insert a blank tape into the VCR and press "RECORD". Stop the

tape after a few moments to test that it is recording.

CHAPTER 3

Technical Tips

The following are problems that might arise when using the PC to

TV converter, and possible solutions to them.

Things to Check :

1. The input on the display (TV, projector, etc.) is not properly set. If

your display has multiple video inputs, then you have to toggle the

inputs to display the one you need. Typically this is done via the

remote.

2. The TV looks fine during boot-up but once the PC enters Windows

all I see is black and white horizontal wavy lines: The display

adapter (video card) is set to a refresh rate not supported by the

converter. Refer to the MODE and RESOLUTION Table in the

beginning of this user’s manual.

The following procedure is required on most typical systems (Note:

your PC may require a different procedure. Please refer to your PCs

documentation for how to adjust the refresh rate for further

information):

Start Menu -> Settings -> Control Panel