Instruction Manual

5
2
Installation
This projection screen should be installed at the best possible viewing position for the audience. Take
out all the parts from the packaging and follow the accessories guideline to ensure you have all the
parts. The parts needed will vary depending on which installation you choose to use. For installation
on a wood wall or ceiling,use 5 x 60 anchors and screws.
Wall Mount
Using a tape measure, measure the distance between the two keyholes on the casing (figure 1).
According to the measurement, use the drill to drill identical holes of the appropriate size on the wall
(use a smaller drill bit than the actual screws) and ensure that it is level (figure 2 & 3). Screw in the
appropriate screws, either 5x60 by itself for wood walls or with anchors for drywalls, leaving enough
space at the end to hang the casing (figure 4). To ensure that the screen is level, use a level to check
(figure 5).
1
2
3
4
A
A
5
Warnings
Ignoring the safety warnings may
lead to injuries and/or damaging
the product.
Refrain from hanging anything on t he
screen as it may cause the scre en to
fall.
Do not connect any electrical
attachments or remote controls.
Fixtures should be installed in a secure
place to avoid accidents or the screen
falling.
Roll up the screen after every use.
Leaving it hanging for a long period
of time may cause the fabric to loosen.
Please contact your local dealer for
repair s or maintenance. Please contact
our company if you have any further
questions. Avoid taking apart the
fixtures yourself. Loose parts may
cause the screen to fall.
Do not take apart and replace with unknown parts. If there are any problems, please contact your local dealer.
Product specifications are subject to change.
The warranty will only be valid if you follow the instructions below carefully! Improper use and care may cause
serious injury and/or damage!.
Make sure the Fixing screw be fastened when using the wall bracket, to avoid any damage.
Make sure the surface you have chosen for installing the screen is flat and secure.
While installing motorized screen, please hire professionals or your local dealer to ensure safety. A wrong
connection may lead to fire or leaks.
If you choose an IR remote control: Ensure that the receiving eye is not pointed directly at a light. This could
result in damage and/or malfunction of the receiver; when installing the screen behind a valance, or in the
ceiling, make sure to plug in the external IR receiver, and place the receiver outside of the valance or ceiling.
Please read the following as any damage to the screen surface will affect the quality of the picture:
1.Avoid contact or touching the screen surface as it may cause scratches or tears.
2.Do not write or draw on the surface.
3.Clean the screen with a soft cloth and lukewarm water. Do not use any detergent or cleaning products.
Roll up the screen after every use. Ensure that the screen is level when installing; do not pull on the sides or
fold the screen.
To prevent unnecessary damage, the operating and maintenance of the screen should be done by adults.