Install Manual

12
Connect the power for projector lift A, and send out directive oxFF ox10 ox11 ox12 oxAA.
At the same time, the address of projector lift A is ox10 ox11 ox12. Entering the operating
address of projector lift A can control this projector lift.
Directive for retracting: 0xFF 0x10 0x11 0x12 0xC9
Directive for stopping: 0xFF 0x10 0x11 0x12 0xCC
Directive for extending: 0xFF 0x10 0x11 0x12 0xE9
Complete the studying in projector lift A, and then disconnect the power for projector
lift A. Please operate the projector lift B in the same way and change the address to
oxAA oxAA oxAA. Entering the operating address of projector B can control this
projector lift.
Directive for retracting: 0xFF 0xAO 0xAA 0xAA 0xC9
Directive for stopping: 0xFF 0xAO 0xAA 0xAA 0xCC
Directive for extending: 0xFF 0xAO 0xAA 0xAA 0xE9
This studying is one address bit for a long time until next address bit change to update.
After studying address bit, the common directive is still eective, so the address bit
cannot be oxEE oxEE oxEE.
Attachment 1
Compare 16 hexadecimal system and 10 hexadecimal system.
16 hexadecimal system 1 2 3 4 5 6 7 8 9 A B C D E F
10 hexadecimal system 1 2 3 4 5 6 7 8 9 10 12 13 14 15 16
4. Remote Controller Instruction
There is a matching function between the controller and projector lift, then the controller
needs to be programmed – follow these steps:
1. The projector lift is at load position. After connecting the power,
within 5 seconds please press the UP button and STOP button simultaneously
for 5 seconds, then release.
2. Press the DOWN button to check whether the programming works.
3. If the programming fails, please repeat steps 1 and 2.