Installation Guide

MATE3 Screens
64 900-0009-01-00 Rev C
Charge Controller Settings
Charge Controller menu options include the following:
Charge
r
------------------------------------------------------------- >
See page 64.
MPP
T
---------------------------------------------------------------- >
See page 64.
Temperature Compensatio
n
------------------------------- >
See page 65.
Battery Equaliz
e
------------------------------------------------ >
See page 65.
Gri
d
-
Tie Mod
e
--------------------------------------------------- >
See page 65.
Auxiliary Outpu
t
------------------------------------------------ >
See page 66.
Restart Mod
e
----------------------------------------------------- >
See page 67.
Calibrat
e
----------------------------------------------------------- >
See page 68.
Rese
t
Charge Controlle
r
to Factory Default
s
-------- >
See page 68.
Charger
IMPORTANT:
Battery charger settings need to be correct for a given battery type. Always follow battery
manufacturer recommendations. Making incorrect settings, or leaving them at factory default
settings, may cause the batteries to be undercharged or overcharged.
The charge controller uses a “three-stage” battery charging cycle which utilizes multiple settings. This
menu controls the voltages and timers for the battery charger. See page 96 for an explanation of the
three-stage cycle and a description of the individual stages.
Figure 61 Charger
MPPT
The charge controller uses a maximum power point tracking (MPPT) algorithm which manipulates the
output of the PV array to harvest maximum wattage. Although this function is automatic, this menu
allows the user to adjust many of its parameters for special applications. See page 47, 48, and 100.
Figure 62 MPPT
Set Points:

MPPT Mode

U-Pick VOC

Wakeup VOC Change VDC and Wakeup VOC
Change Time – The FLEXmax screen refers to these
items under the title “Wakeup Mode”

Snooze Mode Amps

MPP Range Minimum and MPP Range Maximum –
The FLEXmax screen refers to these items under the
title “Mpp Range Limit %”
Set Points:

Absorb Voltage
 (Absorb)
Time

Float Voltage

Rebulk Voltage

Current Limit

Absorb End Am
ps